Do you have room that may utilize a ceiling fan Setting up a ceiling fan on your own is relatively easy, if you are simply replacing a light fixture that is already in the proper location. All of the cabling will already be available, therefore the only obstacle will be replacing the old workbox with one that is accepted for the weight of a ceiling fan. It would be very hazardous if you do not exchange your current workbox to something that can handle the additional weight of the ceiling fan. Before you begin your project, examine the guidelines for the fan you have bought, and be sure that you have all of the essential tools.

If you're going to put in the fan on a cathedral type ceiling, you very well may want to get parts to prolong the fan lower. When you have everything ready to go, the first thing you ought to do is make sure that the breaker is turned off so no power goes to the light fixture. After eliminating the current light fixture, examine to see if the installed workbox can manage the weight of your ceiling fan pre made woodworking plans. Normally they aren't made for a ceiling fan, so you will need to add more support. Including support to the workbox is not that difficult if you have admittance to the light fixture from the attic.

To be able to extra support, you nail a 2x4 inside the ceiling rafters where it hits the top of the workbox. Make sure the 2x4 is anchored in its place, and then bolt the box to the wood. If you did it accurately, the body weight of the fan must be effectively supported by the 2x4 wood and screws. If you don't have access to the attic, you will have to deploy metal cross bracing using the hole in your ceiling. This is harder to do, and most likely not as safe in the end, but definitely will have to do with no attic access.

After you have assembled the fan properly, you are now in a position to hang your fan. The difficult part is holding the fan, while joining the wiring. It depends upon the type of fan you have, many come with a bracket with a J hook while others have a hanging frame. For many fans the wall switch will turn the device on or off, while the chain will manage the speeds. If you need a light kit along with your fan, they can be controlled by either chain or wall switch.

cid woodworking review The next task is to follow along with the wiring guidelines which are as simple as joining two white wires, two black wires and two ground wires. As soon as you have finished the wiring, all you need to do now is affix the blades. Once that is done, turn the breaker back on to check out the results.